"Prewired" 14" Rise 1.5" Diameter Gloss Black "Non ABS" Big Daddy Bar Complete Handlebar Kit for 2008-2013 FLH Harley Touring
Prewired 14" Rise 1.5" Diameter
Black Meathook Bagger Bars 14" Non ABS Handlebar Kit
2008-2013 Harley Davidson FLH
Street Glide/Electra Glide/Ultra Limited/Tri Glide
With the 2008-2013 Harley-Davidson Touring Bikes, the ability to purchase “prewired” bars is typically extremely expensive. The wiring for your stock switches is actually hardwired into your controls and doesn’t allow for the same solution that is available with the late model, 2014-2021, touring line. Based on this we were able to come up with a solution that is far less difficult and time consuming than removing, extending and snaking your existing control harnesses through your new bars. With our solution you are able to utilize our “Prewired” bars with your existing stock switches. We provide the new bars prewired with the control wiring harnesses and our 'Solder Seal' pre-soldered/heat shrink connectors. You will simply cut your own control wire harnesses, strip a small portion, place them into our pre-soldered/heat shrink connectors heat and shrink them. With this process the solder liquifies as well as shrinks the integrated 'shrink' protectant in one simple step! Eliminating a significant portion of the time and work needed to complete the wiring on your Brand New Bar setup...it took some time to come up with our solution, but we have done the hard work for you, leaving you with just the finishing touches. Thus virtually, making these bars Plug and Play. Finally a “prewired” solution for your 2008-2013 touring model that doesn’t break the bank!
- 14" Rise 1.5" Diameter Prewired Gloss Black "Big Daddy" Bagger Bars
- Hydraulic Brake Lines, 1 Upper and 2 Lower Assembled and Ready to Install
- Extended Clutch Cable (Hydraulic Line for CVO)
- Control Switch Extensions
- Electronic Throttle Extension (Harness to be used with/plug into Stock Twist Grip Sensor)
- Banjo Bolts and Washers
- 1.5"Bar Diameter
- 36.5" End to End Width
- 14" Rise
- 5.25' Clamping Surface
- 4.5" Pullback
As an Authorized Dominator Industries Dealer We are Proud to Offer Dominator Meathook Bagger Bars for FLH Touring! Dominator Industries bars are carefully designed to provide natural, relaxed grip angles combined with optimal pullback comfort. They are engineered them to be direct bolt-on replacements for stock equipment with No slag inside the bar tubes making installation easier. Laser cut, fully TIG welded, beveled & de-burred for easy internal wire pulling, and polished to a show their quality finish!
Each and every set of Dominator Industries bars are hand-made employing a multi-step manufacturing process using the finest materials. The tube diameter of 1.5” stepped down to 1.25" for fitment with your stock Fairing, also stepped down to 1” for stock/conventional controls. Both grips have 0.5” x 2” slots laser cut for internal wiring. The throttle side is honed out and notched for fly by wire. The Knurled Center for a non-slip grip on our handlebars is engineered to be a direct custom replacement for stock equipment. Proudly offering smooth and clean arched corners, Dominator Industries provides the premium styling distinguishing riders demand.